Grinding stone holder rubber sliding
Delivery
|
Оn-line 24/7 We are available 7 days a week 24 hours a day |
Shopping Protection We comply with all warranty obligations for all our products. Buying from us you can be sure of the quality of the goods! |
The hand-sharpened stone holder is equipped with three stops, which provides a more reliable and rigid fixation of the abrasive bar. Two metal guides are rigidly fixed in the front stop, are clearly parallel and have no backlash relative to each other. The front and back stops are made of rubberized metal parts, which prevents the fastening jaws from being pushed through even with a strong threaded fixation of the stone. The middle support also has a metal insert that increases its rigidity and allows you to comfortably work with long, but thin stones. The risk of the bar breaking on hard bonds or deflection of the bar on soft bonds (vulcanite, bakelite, etc.) when pressed is eliminated. In the holder, the seating plane of all three supporting parts is perfectly adjusted, the stone on the holder lies clearly over the entire surface, without backlash. The lower part of the holder is equipped with a special tactile notch, which prevents slipping during operation.
One of the main purposes of the sharpening stone holders is to raise the bar above the table level to a height sufficient for comfortable work (so that your hands do not touch the table surface during sharpening). This is especially true for thin stones (as a rule, the thickness of such stones from the manufacturer can be from 10mm). The height of the stone lifting above the table level for this holder is 22 mm, which is more than enough for comfortable work. At the same time, the height of the jaws is 7.5 mm, which makes it possible to fully use the entire length of the stone without the risk of the blade contacting the stubborn jaws.
The maximum length of the stone that can be clamped in the holder is 214 mm. In this case, the standard length of a large stone for manual sharpening is 210 mm. The minimum length of a stone that is fixed in the holder (with a middle support) is 141 mm, which allows it to work quite normally even with standard grinding stones intended for machine sharpening (6 '' or 152.5 mm long).
Characteristics
Material Rubber, steel
Country of origin China
Appointment for fixing abrasive bars for manual sharpening of knives
Minimum stone length 141 mm
Maximum stone length 214 mm
Support surface width 70/62/70 mm
Jaw height 7.5 mm
Raising the stone above the table 22 mm
Overall dimensions 290x70x30 mm
Weight 625 gr.