Weaver base on horizontal shortgun 12k
Delivery
|
Оn-line 24/7 We are available 7 days a week 24 hours a day |
Shopping Protection We comply with all warranty obligations for all our products. Buying from us you can be sure of the quality of the goods! |
The base is designed to create on a 12-caliber double-barreled hunting rifle with a horizontal arrangement of IZH-43, TOZ-66, IZH-54, IZH-58 trunks of two Weaver seats. The Weaver base allows you to mount a collimator sight on the weapon, as well as a barrel-mounted gun lamp or a laser designator.
The installed base covers the aiming bar of the weapon, therefore, it can only be used for mounting a sub-barrel flashlight or laser pointer, without a collimator sight, only by cutting the upper Weaver base along lines 1.
Allowed to use the base on the weapon 16 caliber. The difference in stem diameter between 12 and 16 calibers is approximately 1.7 mm. Therefore, it is required to install additional paronite gaskets with a thickness of 0.8-1.0 millimeters in both halves of the base.
Base specifications:
Length, mm - 52
Height, mm - 43.5
Width, mm - 58
Mass, g - 100
Material - aluminum alloy
Installation base.
The base is installed on the weapon in the following sequence:
1. Put the gun barrels in the lower half of the base (threaded). If necessary, add an additional gasket so that the trunks enter the seat with a light effort to the full depth.
2. Similarly, install the upper half of the base, aligning the holes for the screws.
3. Install the screws and alternately rotate them evenly to tighten the halves of the base, controlling the uniformity of fit and clearances.
Attention! With a fixed base, shooting with a caliber bullet is not recommended!
Installation of the base on the weapon is recommended to be made in the conditions of weapon workshops!